Just finished my build of the Loc IV. Even though no instructions were included I found them online. I deviated from the instructions slightly, so mid motor tube ring could be epoxied from both sides, and leaving aft motor tube ring off until all fins were epoxied from the inside. I was a little disappointed in the nose cone as it had a considerable amount of seam flash. It only caused extra sanding. She’s ready for paint now!!! I am looking forward to March when the club has first launch of the year. I will be using her to achieve my Level 1 certification. All in all a great build. Looking forward to the EZI-65 for Level 2. Great products!!! I will continue this review after she has flown.
Great rocket! Flew mine on a J370 to 4200’. Perfect flight! Can’t wait to fly it again!
Great rocket, perfect for level 1 attempts, strong and a solid weight. Used an H133 to keep it fairly low, went straight as an arrow in 12mph winds. Left off the bottom ring during construction so I could epoxy all around the inside of fins. Put the bottom ring on last.
After watching u tube I chose the Loc 4 to be my level 1cert.rocket.
The LOC-IV flew beautifully with an Aerotech H219T for my L1 cert. Needs minimal ballast to ensure good stability on H and I motors which makes this a very easy kit to build and fly. Something that should be mentioned is that the fins in my kit were smaller than the provided simulation had, so make sure to double check.